DAF 95XF, Manual

Page: 226 / 312

1
CAB TILTING MECHANISM
Removal and installation
95 XF
series
4-2
4.2 REMOVAL AND INSTALLATION, LIFTING CYLINDER
Do not remove the lifting cylinder
while the cab is in the tilted
position.
Removing lifting cylinder
1. Disconnect the pipes and collect the oil in a
container.
Plug off the pipes and connections.
2. Remove the attachment bolts of the
attachment bracket with which the lifting
cylinder is fastened to the top of the cab.
3. Remove the lower attachment bolt used to
attach the lifting cylinder to the chassis, and
remove the lifting cylinder.
4. Remove the attachment bracket (1) of the
lifting cylinder (4) by forcing the pin (2) out
of the bracket, using a press.
; ; ; ; ;
; ; ; ; ;
;; ;;
;;; ;;; ;;;
;; ;;
;;; ;;; ;;;
1 4 2 3
K1 01 454
Installing lifting cylinder
Note:
Use Teflon tape when fitting the pipes to the
nipples. Caution: Do
not use the Teflon tape on
the first turn of the nipple thread. This is to
prevent contamination of the system with Teflon
tape.
1. Apply grease to the attachment rings (3) in
the cylinder eye of the lifting cylinder (4).
Press the pin (2) into the attachment
bracket (1) through the cylinder eye of the
lifting cylinder.
Note:
Press the pin into the attachment bracket
until the conical ends of the pin protrude
fully on either side.
K1 01 502
6
ᓻ 0209