Daewoo Mega 250-V, Operation And Maintenance Manua

Page: 122 / 212

4-12 Inspection, Maintenance and Adjustment K1000896E Operation and Maintenance Manual
7. To add oil, remove transmission fill cap
(Figure 8) from transmission oil fill pipe.
Refer to “Table of Recommended
Lubricants” on page 4-3, of this manual for
recommended oil for the operating
conditions.
8. Shut down engine when done.
CHECK HYDRAULIC SYSTEM OIL LEVEL
1. Move machine to a level area and shut
down engine.
2. Apply parking brake.
3. Lower bucket to ground.
4. Check sight gauge that is attached to
hydraulic reservoir. Oil level must be
between upper limit (1, Figure 12) and
lower limit (2) shown on gauge.
WARNING!
The hydraulic oil will be hot after normal
machine operation. Allow system to cool
before attempting to service any of the
hydraulic components.
The hydraulic tank is pressurized. Turn the
breather cap slowly to allow the
pressurized air to vent. After the pressure
has been released, it is safe to remove
either the fill cap or service covers.
HAAD4540
HOT
COLD
Figure 10 TRANSMISSION SIGHT GAUGE
HAOA060L
Figure 11
Figure 12