DAELIM HISTORY 125 - SERVICE, Service Manual

Page: 88 / 208

8-4
A.C GENERATOR / STARTER CLUTCH
DRIVE FACE HOLDER
PAN SCREW
PAN
SCREW
UNIVERSAL HOLDER
COOLING FAN
RH. CRANKCASE COVER
A.C GENERATOR INSTALLTION
●
Install the stator to the RH. crankcase cover.
●
Clean the tapered portion of the crankshaft.
●
Clean the inside part of the flywheel.
●
Check the woodruff key, install the flywheel by
aligning the groove with the woodruff key.
●
Temporarily install the flywheel nut, hold the flywheel
with the universal holder, and tighten the flywheel nut
with the specified torque.
TORQUE VALUE : 5.0 - 6.0 kgf
·
m
TOOL : UNIVERSAL HOLDER
NOTE
·
If the universal holder cannot be used, remove the
LH. crankcase cover and hold the drive face with the
drive face holder.
TORQUE VALUE : 0.8 - 1.2 kgf
·
m
TOOL : DRIVE FACE HOLDER
●
Install the RH. shroud. (
⇨
8-2 )
●
Connect the A.C.G wiring coupler and connector to the
wire harness, and install the wiring with the clamp.
●
Insert the battery earth cable to the shroud groove.
●
Install the rear cushion under bolt.
●
Install the RH. floor side cover. (
⇨
4-7
)
●
Install the center cover. (
⇨
4-5 )
●
Install the luggage box. (
⇨
4-4
)
RH. CRANKCASE COVER
REMOVAL
●
Loosen the rear cushion under bolt.
●
Remove the following parts.
-
Luggage box (
⇨
4-4
)
-
Center cover (
⇨
4-5 )
-
RH. floor side cover (
⇨
4-7
)
-
RH. shroud (
⇨
8-2
)
-
EX. muffler (
⇨
4-12 )
-
Rear caliper (
⇨
14-6
)
-
Rear swing arm (
⇨
13-8
)
-
Cooling fan (
⇨
8-2 )
-
A.C Generator (
⇨
8-2
)