ENGINE
4) Crankshaft
(A) Flywheel
1. Install the stopper to the flywheel and loosen the
s c r e w.
2. Remove the flywheel stopper and the flywheel.
(When reassembling)
• Clean the end of crankshaft and the mating surface
of the flywheel.
• Apply oil to flywheel screws.
• Fit the flywheel hole to crankshaft hole and tighten
the flywheel bolts to specified torque.
NOTE :
•
Screw longer screws to the flywheel to carry it, if
n e e d e d .
(B) Bearing Case Cover
loosen the screw first inside and next outside, and lift
the cover (1) by screwing two screws gradually and
e v e n l y, refering to the photo.
(When reassembling)
• Apply grease to the oil seal lip and take care that it
is not rolled when installing.
(1) Bearing Case cover
(C) Crankshaft
1. Remove the main bearing case screw 2.
2. Pull out the crankshaft, taking care not to damage
the crankshaft bearing 1.
(When reassembling)
• Apply oil to the bearing case screw.
• Clean the oil passage of the crankshaft with
compressed air.
10.0 to 11.0kgf
•
m
Tightening Flywheel
98.1 to 107.9N
•
m
torque
screw
72.3 to 79.6ft-lbs
2.4 to 2.8kgf
•
m
Tightening Bearing case
23.5 to 27.5N
•
m
torque
cover screw
17.4 to 20.3ft-lbs
7.0 to 7.5kgf
•
m
Tightening Main bearing
68.7 to 73.6N
•
m
torque
case screw 2
50.6 to 54.2ft-lbs
