ENGINE
2) Solenoid
1. Disconnect the stop lever 1(5) from the engine
stop lever (2).
2. Remove the screw (3) ,(4) and (6) .
3. Remove the solenoid(8) with its support.
(When reassembling)
• Loosen the solenoid mouting screws.
• Install the support and complete the linkage
between the solenoid and the engine stop lever.
• Pushing the solenoid plunger to the bottem, pull
the stop lever 2(7) with its until the engine stop
lever (2) is turned to the end, then tighten the
s c r e w s
(1) Screw
(5) Stop lever 1
(2) Engine stop lever
(6) Screw
(3) Screw
(7) Stop lever 2
(4) Screw
(8) Solenoid
3) Inlet Manifold and Fuel Pipes
1. Disconnect the fuel pipe (3).
2. Loosen the injection pipe fitting with two wrenches
and remove the injection pipes (2).
3. Remove the inlet manifold (1) and the fuel transfer
pump (4).
I M P O RTANT :
•
Tighten or loosen injection pipe fittings using the
one-hand two-wrench squeeze method.
•
Cap the nozzle inlet to prevent entrance of foreign
m a t e r i a l s .
(1) Inlet Manifold
(3) Fuel Pipe
(2) Injection Pipe
(4 ) Fuel Transfer Pump
Injection pipe
2.5 to 3.5kgf•m
T i g h t e n i n g
nut 19mm(0.75in) 24.5 to 34.3N•m
t o r q u e
across flats
18.0 to 25.3 ft-lbs
