Page 9-25
S
ECTION
9 - C
OMPONENT
R
EPAIR
Temperature Sensor and Rack
Support
The following applies to all ER36D and
ER48D ovens, including the left oven on
model ER48D:
Turn off the gas supply at the supply valve
and power to the range at the junction or fuse
box.
Remove the oven door as described on page
8-1.
Remove the oven racks from the oven
chamber.
Remove the four (4) screws that hold the
right rack support
H
in place. Be careful not
to scratch the inside surface of the oven when
removing it.
Remove the two (2) screws that hold the
temperature sensor
I
in place. Be careful
not to scratch the baffle when removing the
screws.
When removing the temperature sensor,
pull the wires attached to the sensor gently
toward you through the hole in the back of
the oven to expose the connector. Do not
pull hard on the wires because the connector
may come loose inside the oven wall. Use
a screwdriver, if necessary, to move the
insulation around behind the hole to allow the
connector to slide out into the oven chamber.
Disconnect the temperature sensor wires at
the connector
J
to remove it. Connect the
replacement temperature sensor.
When reinstalling the temperature sensor,
gently push the connector and excess wire
through the access hole and insulation at the
back of the oven.
Tighten the temperature sensor into place
with the two (2) existing mounting screws.
•
•
•
•
•
•
•
•
•
Oven Component Repair (continued)
H
I
J
