Software User Manual
D-Link Unified Access System
02/15/2011
Document 34CS3000-SWUM104-D10
Page 139
Status entries in the RF Scan list are collected at a point in time and eventually age out. The age value for each entry shows
how long ago the switch recorded the entry. You can configure the age out time for status entries on the
Administration >
Advanced Configuration > Global
page. You can also manually delete status entries. To clear all APs from the RF scan
list, click
Delete All
.
To configure a Rogue AP to be managed by the switch the next time it is discovered, select the check box next to the MAC
address of a detected AP and click
Manage
. You will be presented with the
Valid Access Point Configuration
page. You
can then configure the AP and click
Submit
to save the AP in the local Valid AP database. If you use a RADIUS server for
AP validation, you must add the MAC address of the AP to the AP database on the RADIUS server. For more information,
see Appendix B:, “Configuring the External RADIUS Server” on page 207.
Figure 64: RF Scan
To identify an AP as an acknowledge rogue, select the check box next to the MAC address of the AP and click
Acknowledge
. The switch adds the AP to the Valid AP database as an Acknowledged Rogue. To identify an AP as a rogue
(again), select the check box next to the MAC address of the acknowledged AP and click
Unacknowledge
. The switch
deletes the AP from the Valid AP database.
•
Click
Refresh
to update the screen with the most current information.
•
When the
Auto Refresh
option is selected, the page will be refreshed after every 30 seconds.
When you manage or acknowledge a rogue AP, the switch adds an entry to the valid AP database but does not change the
entry on the RF Scan Status page. However, the next time the switch discovers the AP, its entry in the RF Scan Status list
will be handled based on the change.
To view additional information about the detected AP, click the MAC address of the AP. Click
Back
to see the list of Rogue/
RF Scan Access Points.
Note:
You cannot sort the list in the
Under Mitigation
column.
