D-Link Unified Access System
Software User Manual
02/15/2011
Page 110
Document 34CS3000-SWUM104-D10
The Current Status of the plan shows one of the following states:
•
None—The channel plan algorithm has not been manually run since the last switch reboot.
•
Algorithm In Progress—The channel plan algorithm is running.
•
Algorithm Complete—The channel plan algorithm has finished running. A table displays to indicate proposed channel
assignments. Each entry shows the AP along with the current and new channel. To accept the proposed channel
change, click
Apply
. You must manually apply the channel plan for the proposed assignments to be applied.
•
Apply In Progress—The switch is applying the proposed channel plan and adjusting the channel on the APs listed in the
table.
•
Apply Complete—The algorithm and channel adjustment are complete.
After the channel plan runs, a table shows any APs that the algorithm recommends for new channel assignments. The
current channel shows the current operating channel, and the new channel shows the proposed channel. To apply the new
channels, click
Apply
. If no APs appear after the algorithm is complete, the algorithm does not recommend any channel
changes.
Use the buttons at the bottom of the page to perform the following tasks:
•
Click
Clear
to reset the page to the default values.
•
Click
Refresh
to update the screen with the most current information.
It is possible for the network configuration to change between the time the automatic channel selection runs and the time
you attempt to apply the proposed channel assignments.
The channel will fail to be applied to an AP if one of the following conditions exist:
•
The AP has failed.
•
The radio on the AP has been disabled through a profile update.
•
The channel is not valid for the radio mode.
•
The AP has been rebooted since the channel plan was computed and acquires a static channel that has been set
statically via local database.
•
The channel has been set manually through the advanced page.
•
The auto-channel mode has been disabled in the profile for this AP.
Initiating Manual Power Adjustments
If you select Manual as the Power Adjustment Mode on the Configuration tab, you can manually initiate the power adjustment
algorithm on the
Manual Power Adjustments
page.
Figure 53: Manual Power Adjustments
