D-Link 10 Gigabit Ethernet Switch User Manual
3
3
2
2
Figure 4.32 – System > Port Configuration > Error Disable Settings
The fields that can be configured are described below:
Asserted:
Select this option to enable or disable the notifications when entering into the error disabled state.
Cleared:
Select this option to enable or disable the notifications when exiting from the error disabled state.
Notification Rate:
Enter the number of traps per minute. The packets that exceed the rate will be dropped.
The value is between 0 and 1000.
ErrDisable Cause:
Select the error disable causes here. Options to choose from are All, Port Security,
Storm Control, and Loopback Detect.
State:
Select this option to enable or disable the auto-recovery for an error port caused by the specified
cause.
Interval:
Enter the time between 5 and 86400 seconds to recover the port.
Click
Apply
to accept the changes made for each individual section.
System > Port Configuration > Jumbo Frame
This window is used to view and configure the Jumbo Frame size and settings. The Switch supports jumbo
frames. Jumbo frames are Ethernet frames with more than 1,536 bytes of payload. The Switch supports
jumbo frames with a maximum frame size of up to 9,216 bytes.
