D-Link DWS-1008 CLI Manual
8
condition-list
Match criteria for packets. Conditions in the list are ANDed. Therefore,
to be copied and sent to an observer, a packet must match all criteria in
the
condition-list
. You can specify up to eight of the following conditions
in a filter, in any order or combination:
•
frame-type {eq | neq} {beacon | control | data | management
| probe}
•
channel {eq | neq}
channel
•
bssid {eq | neq}
bssid
•
src-mac {eq | neq | lt | gt}
mac-addr
•
dest-mac {eq | neq | lt | gt}
mac-addr
•
host-mac {eq | neq | lt | gt}
mac-addr
•
mac-pair
mac-addr1 mac-addr2
To match on packets to or from a specific MAC address, use the
dest-
mac or src-mac option. To match on both send and receive traffic for a
host address, use the
host-mac option.
To match on a traffic flow (source and destination MAC addresses), use
the
mac-pair option. This option matches for either direction of a flow,
and either MAC address can be the source or destination address.
If you omit a condition, all packets match that condition. For example, if
you omit frame-type, all frame types match the filter.
For most conditions, you can use
eq (equal) to match only on traffic
that matches the condition value. Use
neq (not equal) to match only on
traffic that is not equal to the condition value.
The
src-mac, dest-mac, and host-mac conditions also support lt (less
than) and gt (greater than).
observer
ip-addr
Specifies the IP address of the station where the protocol analyzer is
located. If you do not specify an observer, the AP radio still counts the
packets that match the filter.
snap-length
num
Specifies the maximum number of bytes to capture. If you do not specify
a length, the entire packet is copied and sent to the observer. D-Link
recommends specifying a snap length of 100 bytes or less.
Defaults: No snoop filters are configured by default.
Access: Enabled.
Summary of Contents for DWS-1008
Page 1: ......
Page 27: ...D Link DWS 1008 CLI Manual 24 ...
