D-Link DWS-1008 CLI Manual
11
set ip ssh
Changes the TCP port number on which a DWS-1008 switch listens for Secure Shell (SSH)
management traffic.
Caution: If you change the SSH port number from an SSH session, MSS immediately ends the
session. To open a new management session, you must configure the SSH client to use the new
TCP port number.
Syntax: set ip ssh port
port-num
port-num
TCP port number.
Defaults: The default SSH port number is 22.
Access: Enabled.
Examples: The following command changes the SSH port number on a DWS-1008 switch to
6000:
DWS-1008#
set ip ssh port 6000
success: change accepted.
set ip ssh server
Disables or reenables the SSH server on a DWS-1008 switch.
Caution: If you disable the SSH server, SSH access to the switch is also disabled.
Syntax: set ip ssh server {enable | disable}
enable
Enables the SSH server.
disable
Disables the SSH server.
Defaults: The SSH server is enabled by default.
Access: Enabled.
Usage: SSH requires an SSH authentication key. You can generate one or allow MSS to generate
one. The first time an SSH client attempts to access the SSH server on a DWS-1008 switch, the
switch automatically generates a 1024-byte SSH key.
If you want to use a 2048-byte key instead, use the
crypto generate key ssh 2048 command to
generate one.
The maximum number of SSH sessions supported on a switch is eight. If Telnet is also enabled,
the switch can have up to eight Telnet or SSH sessions, in any combination, and one Console
session.
Summary of Contents for DWS-1008
Page 1: ......
Page 27: ...D Link DWS 1008 CLI Manual 24 ...
