D-Link DWS-1008 CLI Manual
108
snmp-engine-id
SNMP engine ID of the target. Specify ip if the target’s SNMP
{ip | hex
hex-string
}
engine ID is based on its IP address. If the target’s SNMP
engine ID is a hexadecimal value, use
hex
hex-string
to
specify the value.
profile
profile-name
Notification profile this SNMP user will use to specify the
notification types to send or drop.
security {unsecured |
Specifies the security level, and is applicable only when the
authenticated | encrypted}
SNMP version is usm:
•
unsecured—Message exchanges are not authenticated,
nor are they encrypted. This is the default.
•
authenticated—Message exchanges are authenticated,
but are not encrypted.
•
encrypted—Message exchanges are authenticated and
encrypted.
retries num
Specifies the number of times the MSS SNMP engine will
resend a notification that has not been acknowledged
by the target. You can specify from 0 to 3 retries.
timeout num
Specifies the number of seconds MSS waits for
acknowledgement of a notification. You can specify from 1 to
5 seconds.
SNMPv3 with Traps
To configure a notification target for traps from SNMPv3, use the following command:
Syntax: set snmp notify target
target-num ip-addr
[
:udp-port-number
]
usm trap user
username
[profile
profile-name
]
[security {unsecured | authenticated | encrypted}]
target-num
ID for the target. This ID is local to the switch and does not need to
correspond to a value on the target itself. You can specify a number
from 1 to 10.
ip-addr[:udp-port-number]
IP address of the server. You also can specify the UDP port number
to send notifications to.
username
USM username. This option is applicable only when the SNMP
version is usm.
profile
profile-name
Notification profile this SNMP user will use to specify the notification
types to send or drop.
Summary of Contents for DWS-1008
Page 1: ......
Page 27: ...D Link DWS 1008 CLI Manual 24 ...
