D-Link DWS-1008 CLI Manual
RF Detection Commands
MSS automatically performs RF detection scans on enabled and disabled radios to detect rogue access
points. A rogue access point is a BSSID (MAC address associated with an SSID) that does not belong
to a D-Link device and is not a member of the ignore list configured on the seed switch.
MSS can issue countermeasures against rogue devices to prevent clients from being able to use
them.
You can configure RF detection parameters on individual switches.
This chapter presents RF detection commands alphabetically. Use the following table to locate the
commands in this chapter based on their use.
Rogue Information
show rfdetect clients on page 275
show rfdetect data on page 280
show rfdetect visible on page 283
show rfdetect counters on page 278
Countermeasures
show rfdetect countermeasures on page 277
Permitted Vendor List
set rfdetect vendor-list on page 274
show rfdetect vendor-list on page 282
clear rfdetect vendor-list on page 269
Permitted SSID List
set rfdetect ssid-list on page 273
show rfdetect ssid-list on page 282
clear rfdetect ssid-list on page 269
Client Black List
set rfdetect black-list on page 270
show rfdetect black-list on page 285
Attack List
set rfdetect attack-list on page 270
show rfdetect attack-list on page 274
clear rfdetect attack-list on page 268
Ignore List
set rfdetect ignore on page 271
show rfdetect ignore on page 281
clear rfdetect ignore on page 268
AP Signatures
set rfdetect signature on page 272
Log Messages
set rfdetect log on page 272
DWS-to-Client RF Link test rflink on page 284
Summary of Contents for DWS-1008
Page 1: ......
Page 27: ...D Link DWS 1008 CLI Manual 24 ...