D-Link DWL-3600AP, Administrator'S Manual

Page: 129 / 183

Configuring VAP QoS Parameters
D-Link Unified Access Point Administrator’s Guide
November 2011 Page 129
Unified Access Point Administrator’s Guide
Figure 40: VAP QoS Parameters
Table 52: VAP QoS Parameters
Field Description
Client QoS Global Admin
Mode
Enable or disable Client QoS operation on the AP.
Changing this setting will not affect the WMM settings you configure on the
QoS page.
Radio For dual ‐ radio APs, select Radio 1 or Radio 2 to specify which radio to
configure.
VAP Specify the VAP that will have the Client QoS settings that you configure.
The QoS settings you configure for the selected VAP will not affect clients that
access the network through other VAPs.
Client QoS Mode Enable or disable QoS operation on the VAP selected in the VAP menu.
QoS must be enabled globally (from the Client QoS Global Admin Mode field)
and on the VAP ( QoS Mode field) for the Client QoS settings to be applied to
wireless clients.
Bandwidth Limit Down Enter the maximum allowed transmission rate from the AP to the wireless
client in bits per second. The valid range is 0 – 429496000 bits/sec.
The value you enter must be a multiple of 8000 bits/sec, in other words, the
value must be n × 8000 bits/sec, where n = 0, 1, 2, 3... If you attempt to set the
limit to a value that is not a multiple of 8000 bits/sec, the configuration will be
rejected. A value of 0 means that the bandwidth maximum limit is not enforced
in this direction.