DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
93
19-2
show channel-group
This command is used to display the channel group information.
show channel-group [channel [
CHANNEL-NO
] {detail | neighbor} | load-balance | sys-id]
Parameters
CHANNEL-NO
(Optional) Specifies the channel group ID.
channel
(Optional) Specifies to display information for the specified port-
channels.
detail
(Optional) Specifies to display detailed channel group information.
neighbor
(Optional) Specifies to display neighbor information.
load-balance
(Optional) Specifies to display the load balance information.
sys-id
(Optional) Specifies to display the system identifier that is being
used by LACP.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If a port-channel number is not specified, all port-channels will be displayed. If the channel, load- balance and
sys-id keywords are not specified with the show channel-group command, only summary channel-group
information will be displayed.
Example
This example shows how to display the detailed information of all port-channels.
Switch# show channel-group channel detail
Flag:
S - Port is requesting Slow LACPDUs F - Port is requesting fast LACPDU
A - Port is in active mode P - Port is in passive mode
LACP state:
bndl: Port is attached to an aggregator and bundled with other ports.
hot-sby: Port is in a hot-standby state.
indep: Port is in an independent state(not bundled but able to switch data
traffic)
down: Port is down
Channel Group 1