DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
29
None.
Command Mode
EXEC Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the test results for the cable diagnostics.
Example
This example shows how to display the test results for the cable diagnostics.
Switch# show cable-diagnostics interface Ethernet 1/0/1-2
Port Type Link Status Test Result Cable Length (M)
--------- ---------- ------------- ------------------------- -----------------
eth1/0/1 1000BaseT Link Down Pair 1 Open at <7M -
Pair 2 Open at <7M -
Pair 3 Short at <7M -
Pair 4 OK at <7M -
eth1/0/2 1000BaseT Link Down Pair 1 Open at <7M -
Pair 2 Open at <7M -
Pair 3 Short at <7M -
Pair 4 OK at <7M -
7-3
clear cable-diagnostics
This command is used to clear the test results for the cable diagnostics.
clear cable-diagnostics {all | interface
INTERFACE-ID
}
Parameters
all
Specifies to clear cable diagnostics results for all
interfaces.
interface
INTERFACE-ID
Specifies the interface’s ID. The acceptable interface
will be a physical port.
Default
None.
Command Mode
EXEC Mode.
Command Default Level
Level: 15.