DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
31
8.
Digital Diagnostics Monitoring (DDM)
Commands
8-1
show interfaces transceiver
This command is used to display the current SFP module operating parameters.
show interfaces [
INTERFACE-ID
[,|-] transceiver [detail]
Parameters
INTERFACE-ID
[,|-]
(Optional) Specifies multiple interfaces for transceiver monitoring
status display. If no interface ID is specified, transceiver
monitoring statuses on all valid interfaces are displayed.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the current SFP module operating transceiver monitoring parameters values for
specified ports.
Example
This example shows how to display current operating parameters for all ports valid for transceiver monitoring.
Switch# show interfaces transceiver
++ : high alarm, + : high warning, - : low warning, -- : low alarm
mA: milliamperes, mW: milliwatts
Transceiver Monitoring traps: None
Port
Temperature Voltage Bias Current
TX Power
RX Power
(Celsius) (V) (mA)
(mW)
(mW)
------- ------------ ------------ ------------ ------------ ------------
eth1/0/11 29.316 3.302 5.326 0.529 0.506
eth1/0/12 31.617 3.297 5.170 0.527 0.504
Total Entries: 2
Switch#
This example shows how to display detailed transceiver monitoring information for all ports which are valid for
transceiver monitoring.
Switch# show interfaces transceiver detail