DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
122
Command Default Level
Level: 15.
Usage Guideline
Use this command to enable sending PoE usage threshold exceeding traps.
Example
This example shows how to enable trap for PoE event.
Switch#configure terminal
Switch(config)#snmp-server enable traps poe
Switch(config)#
25-4
show poe power-inline
This command is used to display the Power over Ethernet (PoE) status for the specified PoE port, or for all PoE
ports in the switch system.
show poe power-inline [
INTERFACE-ID
[, | -]] {status | configuration}
Parameters
INTERFACE-ID
(Optional) Specifies the interface to be displayed.
,
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces before and after the
comma.
-
(Optional) Specifies a range of interfaces. No spaces before and
after the hyphen.
status
Specifies to display the port PoE status.
configuration
Specifies to display the port configuration information.
Default
None
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the PoE status of ports, power inline configuration status. If the interface ID is
not specified with this command, then all PoE interfaces will be displayed. Only the PoE capable interfaces are
displayed.
Example
This example shows how to display the PoE power inline status.