DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
35
8-5
transceiver-monitoring enable
This command is used to enable the optical transceiver monitoring function for an SFP port. Use the
no
form of
the command to disable optical transceiver monitoring.
transceiver-monitoring enable
no transceiver-monitoring enable
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
This command is available for the physical port interface configuration.
A user can use this command to enable or disable optical transceiver monitoring function for an SFP port. When
the monitoring function is enabled, an alarm event occurs when the parameters being monitored go higher than
the high alarm threshold or go lower than the low alarm threshold. A warning event occurs when the parameters
being monitored go higher than the high warning threshold or go lower than the low warning threshold.
When an SFP with transceiver monitoring capability is plugged into a port but the transceiver monitoring
function of the port is disabled, the system will not detect the SFP's abnormal status but the user can still check
the current status by showing the interface transceiver command.
Example
This example shows how to enable transceiver monitoring on interface eth1/0/11.
Switch# configure terminal
Switch(config)# interface Ethernet 1/0/11
Switch(config-if)# transceiver-monitoring enable
Switch(config-if)#
8-6
transceiver-monitoring rx-power
This command is used to configure the thresholds of the input power for the specified port. Use the
no
form of
the command to remove the configuration.
transceiver-monitoring rx-power
INTERFACE-ID
{high | low} {alarm | warning} {mwatt
VALUE
| dbm
VALUE
}
no transceiver-monitoring rx-power
INTERFACE-ID
{high | low} {alarm | warning}