DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
32
++ : high alarm, + : high warning, - : low warning, -- : low alarm mA:
milliamperes, mW: milliwatts
A: The threshold is administratively configured.
eth1/0/11
Transceiver Monitoring is enabled
Transceiver Monitoring shutdown action
:
Alarm
Current High-Alarm High-Warning
Low-Warning Low-Alarm
Temperature(C) 30.090 75.000(A)
70.000 0.000 -5.000
Voltage (v) 3.353 3.630
3.465 3.135 2.970
Bias Current(mA)
16.794(++) 10.500 9.000 2.500 2.000
TX Power (mW) 0.258 1.413
0.708 0.186 0.074
RX Power (mW) 0.000(--) 1.585 0.794 0.102 0.041
Switch#
8-2
snmp-server enable traps transceiver-monitoring
This command is used to send all or the specified level of optical transceiver monitoring SNMP notifications.
Use the
no
form of the command to stop sending the notifications.
snmp-server enable traps transceiver-monitoring [{alarm | warning}]
no snmp-server enable traps transceiver-monitoring [{alarm | warning}]
Parameters
alarm
(Optional) Specifies to send or stop sending alarm level
notification.
warning
(Optional) Specifies to send or stop sending warning level
notification.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to send all or the specified level of transceiver-monitoring SNMP notifications.
Example
This example shows how to start sending the SNMP notifications at the warning level.
Switch# configure terminal