DGS-6604
m
tunnel destination
CLI Reference Guide
913
tunnel destination
Use the
tunnel destination
configuration command to add the destination IPv4
address for the tunnel interface. Use the
no tunnel destination
configuration
command to remove it.
tunnel destination {
IPv4-ADDRESS
}
no tunnel destination
Default
None
Command Mode
Interface configuration
Usage Guideline
Use these commands to configure the destination IPv4 address for a tunnel
interface.
Tunnel interfaces are valid for this command. Only manually configured tunnels
need to set the tunnel destination.
Examples
This example shows how to add the destination IPv4 address for the tunnel
interface 2
This example shows how to remove the destination IPv4 address for the tunnel
interface 2
Verify the settings by entering the
show interface
command.
Syntax Description
IPv4-ADDRESS
Specifies the IPv4 address as the the destination address for the tunnel.
Switch(config)# interface tunne 2
Switch(config-if)#tunnel destination 10.0.0.1
Switch(config-if)#
Switch(config)# interface tunne 2
Switch(config-if)#no tunnel destination
Switch(config-if)#
Summary of Contents for DGS-6600-48TS
Page 1: ...0 9 3...
