DGS-6604
m
set ip default next-hop
CLI Reference Guide
559
set ip default next-hop
Use the command in route-map configuration mode to set the next hop to route
the packets that pass a match clause of a route map and there is no route for the
packets. To remove the setting, use the
no
form of the command to remove the
setting.
set ip default next-hop
IP-ADDRESS
no set default next-hop [
IP-ADDRESS
]
Default
Not configured
Command Mode
Route-map configuration
Usage Guideline
If other set clauses for policy based routing are used with the command, they will
be evaluated based on the following ordering:
1. set ip next-hop
2. set interface
3. set ip default next-hop
4. set default interface
With this ordering, the set next-hop clauses and the set interface clauses will be
evaluated before look up of the routing table. If route cannot be found for the
packets, the set ip default next-hop and set default interface command will be
evaluated.
Example
In the following example, PBR will change the next-hop setting when the source
ip is 10.1.1.0/24,vlan is vlan100 and can not found the destination address in
routing table. We want to set next-hop of this route entry to 120.1.2.2. The steps
as follows:
At first, create an IP basic access list, named Strict-Control which permit prefix
10.1.1.0/24.
Secondly, create a route map, named
myPolicy
which define a match rule to
associate ip address prefix-list to the previously created access list, Strict-
Control.
Syntax Description
IP-ADDRESS
Specify the next hop to route the packet. the next hop must be an adjacent
router.
Summary of Contents for DGS-6600-48TS
Page 1: ...0 9 3...
