DGS-6604
m
show ipv6 neighbors
CLI Reference Guide
708
show ipv6 neighbors
This command is used to display the IPv6 neighbor information.
show ipv6 neighbors
Default
None
Command Mode
User EXEC or any configuration mode
Usage Guideline
None
Example
The example shows how to display IPv6 neighbor information.
Display Field
Descriptions
Description of significant display fields.
Switch > enable
Switch # show ipv6 neighbors
IPv6 Address MAC Address Interface Type Status
fe80::250:baff:fef9:b512 0050.baf9.b512 vlan1 DYNM STALE
Switch #
Display Field
Description
Type
DYNM - Dynamic learning entry.
STATIC - Static neighbor entry (for example, user configuration)
LOCAL - Local interface entry.
Status
REACH (Reachable) - Positive confirmation was received within the last
ReachableTime, in milliseconds, that the forward path to the neighbor was
properly functioning. While in the REACH state, the device takes no special
action as packets are sent.
STALE - More than the ReachableTime, in milliseconds, has elapsed since
the last positive confirmation was received that the forward path was properly
functioning. While in the STALE state, the device takes no action until a
packet is sent.
DELAY - More than ReachableTime, in milliseconds, has elapsed since the
last positive confirmation was received that the forward path was properly
functioning. A packet was sent within the last DELAY_FIRST_PROBE_TIME
seconds. If no reaching confirmation is received within the
DELAY_FIRST_PROBE_TIME in seconds of entering the DELAY state, send
a neighbor solicitation message and change the state to PROBE.
PROBE - A reaching confirmation is actively sought by resending neighbor
solicitation messages every RetransTimer, in milliseconds.
Summary of Contents for DGS-6600-48TS
Page 1: ...0 9 3...
