DGS-6604
mm
dot1x auth-mode
CLI Reference Guide
169
dot1x auth-mode
Use the
dot1x auth-mode
command to specify the 802.1x authentication mode.
dot1x auth-mode {port-based
|
host-based}
Default
port-based mode
Command Mode
Interface configuration
Usage Guideline
The maximum number of hosts allowed to connect to an 802.1X-enabled port is
project-dependent.
Example
The following example shows how to specify the authentication mode as host-
based.
Verify the settings by entering the
show dot1x auth-configuration
command.
Syntax Description
port-based
Specifies the authentication mode as port-based. When in the port-based mode
if one supplicant is successfully authenticated, other hosts that are connected to
the same port are allowed to access the port. Each port implements one
authenticator state machine.
host-based
Specifies the authentication mode as host-based. When in the host-based mode,
each host is identified by its MAC address. Only hosts which are successfully
authenticated are allowed to access the port. Each MAC address implements
one authenticator state machines.
Switch(config)#interface eth4.3
Switch(config-if)# dot1x auth-mode host-based
Summary of Contents for DGS-6600-48TS
Page 1: ...0 9 3...
