DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual
13
Automatic Link
Local Address
Enables or disables the automatic configuration of link local addresses when there are no IPv6
addresses explicitly configured. When an IPv6 address is explicitly configured, the link local
address will be automatically configured, and the IPv6 processing will be started. When there is
no IPv6 address explicitly configured, by default, link local address is not configured and the IPv6
processing will be disabled. By enabling this automatic configuration, the link local address will be
automatically configured and IPv6 processing will be started.
Click
Apply
to implement changes made.
IPv6 Route Settings
This window allows the user to create and configure IPv6 Route interfaces to the Switch’s IP routing table.
To view this window, click
Configuration
> IPv6 Route Settings
as shown below:
Figure 2 - 9 IPv6 Route Settings window
The following parameters can be configured:
Parameter Description
Interface Name
Enter the name you wish to give the IPv6 Route Interface.
Nexthop
Address
Enter the IPv6 address for the next hop router.
Metric (1-65535)
Allows the entry of a routing protocol metric entry representing the number of routers between the
Switch and the IP address above. The default setting is 1.
Backup State
The user may choose between Primary and Backup. If the Primary Static/Default Route fails, the
Backup Route will support the entry.
Click
Apply
to implement changes made. To remove any entry, click the
Delete All
button.
IPv6 Neighbor Settings
This window allows the user to create and configure IPv6 Neighbor settings on the Switch. The Switch’s current IPv6
neighbor settings will be displayed in the table at the bottom of this window.
To view this window, click
Configuration
> IPv6 Neighbor Settings
as shown below:
Figure 2 - 10 IPv6 Neighbor Settings window
The following parameters can be configured:
