DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual
197
Switch
Replace DSCP
Select this option to instruct the Switch to replace the DSCP value (in a packet that meets
the selected criteria) with the value entered in the adjacent field.
Replace ToS
Precedence
Select this option to instruct the Switch to replace the Type of Service as part of the packet
header.
VLAN Mask
Allows the entry of a name for a previously configured VLAN.
VLAN ID
Allows the entry of a VLAN ID for a previously configured VLAN.
DSCP
Selecting this option instructs the Switch to examine the DiffServ Code part of each packet
header and use this as the criteria, or part of the criterion for forwarding.
ICMP
Select
ICMP
to instruct the Switch to examine the Internet Control Message Protocol (ICMP)
field in each frame's header.
Rx Rate (1-15624)
Use this to limit Rx bandwidth for the profile being configured. This rate is implemented
using the following equation: 1 value = 64Kbit/sec. (ex. If the user selects an Rx rate of
10
then the ingress rate is 640Kbit/sec.) The user many select a value between
1
and
15624
or
tick the No Limit check box. The default setting is No Limit.
Time Range Name
Tick the check box and enter the name of the Time Range settings that has been previously
configured in the
Time Range
Settings
window. This will set specific times when this
access rule will be implemented on the Switch.
Counter
Enable or disable the counter settings.
Ports
Specifies that the access rule will take effect on one port or a range of ports.
VLAN Name
Specifies the access rule will take effect on the VLAN Name specified.
VLAN ID
Specifies the access rule will take effect on the VLAN ID specified.
Click
Apply
to display the following Access Rule List window.
Figure 6 - 14 Access Rule List (IPv4)
To view the configurations for previously configured rule click on the corresponding
Show Details
Button which will
display the following
Access Rule Details
window.
Figure 6 - 15 Access Rule Detail Information
To configure the
IPv6 ACL
select IPv6 in the Add ACL Profile window, enter the Profile ID and Profile Name into the
top half of the screen in the
Add ACL Profile
window and click
Select,
the following window will appear.
