DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
372
•
auto –
Allows the port’s status to reflect the outcome of the
authentication process.
•
force_unauth –
Forces the Authenticator for the port to
become unauthorized. Network access is blocked.
quiet_period <sec 0-65535> –
Configures the time interval between
authentication failure and the start of a new authentication attempt.
tx_period <sec 1-65535>
- Configures the time to wait for a
response from a supplicant (user) to send EAP Request/Identity
packets.
supp_timeout <sec 1-65535>
- Configures the time to wait for a
response from a supplicant (user) for all EAP packets, except for the
Request/Identity packets.
server_timeout <sec 1-65535>
- Configures the length of time to wait
for a response from a RADIUS server.
max_req <value 1-10>
– Configures the number of times to retry
sending packets to a supplicant (user).
reauth_period <sec 300-4294967295>
– Configures the time interval
between successive re-authentications.
enable_reauth [enable | disable] –
Determines whether or not the
Switch will re-authenticate. Enabled causes re-authentication of
users at the time interval specified in the Re-authentication Period
field, above.
direction [both | in] –
Sets the administrative-controlled direction to
Both
. If
Both
is selected, control is exerted over both incoming and
outgoing traffic through the controlled port selected in the first field.
The
In
option is not supported in the present firmware release.
Restrictions
Only Administrator, operator or power user-level users can issue this
command.
Example usage:
To configure 802.1x authentication parameters for ports 1 – 20:
DGS-1210-28MP/ME:5# config 802.1x auth_parameter ports 1-5 direction both
Command: config 802.1x auth_parameter ports 1-5 direction both
Success.
DGS-1210-28MP/ME:5#
config 802.1x init
Purpose
To initialize the 802.1x function on a range of ports.
Syntax
config 802.1x init port_based ports [<portlist> | all]
Description
The
config 802.1x init
command initializes the 802.1x functions on
a specified range of ports or for specified MAC addresses operating
from a specified range of ports.
Parameters
port_based
– Instructs the Switch to initialize 802.1x functions based
only on the port number. Ports approved for initialization can then be
specified.
ports <portlist>
– A port or range of ports to be configured.
all –
Specifies all of the ports on the Switch.
