DES-3226L Layer 2
Fast Ethernet Switch User’s Guide
The following parameters can be set:
Parameter
Description
Community Name
Type an alphanumeric string of up to 33 characters that is used to identify
members of an SNMP community. This string is used like a password to
give remote SNMP managers access to MIB objects in the Switch’s
SNMP agent.
View Name
Type an alphanumeric string of up to 32 characters that is used to identify
the group of MIB objects that a remote SNMP manager is allowed to
access on the Switch. The view name must exist in the SNMP View
Table.
Access Right
read_only
−
Specifies that SNMP community members using the
community string created with this command can only read the contents
of the MIBs on the Switch.
read_write
−
Specifies that SNMP community members using the
community string created with this command can read from and write to
the contents of the MIBs on the Switch.
SNMP Host Table
Use the
SNMP Host Table
to set up SNMP trap recipients.
Open the
Basic Setup
folder to
Network Management,
and then the
SNMPV3
folder.
Finally, click on the
SNMP Host Table
link. This will open the
SNMP Host Table
page, as
shown below.
To delete an existing SNMP Host Table entry, click the corresponding radio button entry and
then the
Delete
button.
Figure 5-18. SNMP Host Table window
To add a new entry to the switch’s SNMP Group Table, click the
New
button in the upper
left-hand corner of the
SNMP Host Table
page. This will open the
SNMP Host Table - Add
page, as shown below.
39
