D-Link DCS-6220G, User Manual

Page: 9 / 145

9
DCS-660G User’s Manual
D-Link Systems, Inc.
Hardware Installation
Attaching the Internet Camera to the Camera Stand
Hardware Installation
The Internet Camera comes with a camera stand with a swivel ball screw head that
can be attached to the Internet Camera bottom socket cavity. Attach the camera stand
to the Internet Camera and station it for your application. There is a hole located
in the base of the camera stand allowing the Internet Camera to be mounted to the
ceiling, or any wall securely.
Power LED
LED stands for
L ight-
E
mitting
D
iode.
The Power LED is positioned in the center of the Internet Camera base. As soon as the power adapter is
connected to the Internet camera, the power and the activity LED will flash red and green several times. The
DCS-6620G is conducting a self-test. Upon passing the self-test, the red LED will be solid and the green
LED will start to blink to indicate a good connection to an Ethernet port. If you are directly connected
to the camera via a crossover cable, the light may cycle on and off and your computer may show
an intermittent loss of connectivity. This is normal until you have configured your Internet Camera. The
absence of a blinking green LED indicates no connection has been made.
1 Connect the Ethernet Cable
Connect one end of the Ethernet cable to the network cable connec-
tor located on the back panel of the DCS-6620G, and attach the other
end to a router, switch, or gateway on the network.
If you connect this camera directly to a PC, you will need a cross-over Ethernet cable. If
you plug the camera into a hub or router, you will be able to use the cable included with
your camera.
2 Attach the External Power Supply
Attach the external power supply to the DC power input connector locat-
ed on the backpanel of the DCS-6620G (labeled 12V), and connect
it to an AC power outlet.
Both the
red and green LEDs will flash alternately and only the red LED
will remain lit. The green LED will not come on until you have configured
your camera.
3 Attach the Antennas
Attach the two antennas to the connectors located on the back
panel of the DCS-6620G.
It is required that an Ethernet cable is used during initial setup. Once your wireless configura-
tion is set, you may disconnect the Ethernet cable and reboot your camera to connect to
your wireless network.
Power source is confirmed when the LED Power Indicator on the 80.11g PTZ Internet
Camera is illuminated.