D-Link DCS-6220, User Manual

Page: 86 / 143

86
DCS-660 User’s Manual
D-Link Systems, Inc.
Using IP surveillance Software
Modulation Mode
You must select the input signal format (NTSC or PAL) for displaying the original
resolution of video stream from DCS-6620 . If you are not sure which format to select,
then leave the input signal format at it’s default (NTSC).

Note: You need to select the input signal format according to the camera type or CCD
module type that is connected to the DCS-6620.
Display Options:
In the video displaying frame of each channel, there are two status bars. The upper bar contains “Camera
location” and “time of the remote site.” The lower bar contains “Connection time” and “Recording
time.” All of them, shown in the figure below, can be enabled or disabled here individually for the status
indication. Apply to full screen mode can also be turned on here. Once it has been checked, the status
bar in each channel showing date, location, connection, and recording time will be shown in both display
frame mode and full screen mode.
0 day 00:01
Location (channel camera name)
Remote Time
Connection Time (Day:Hour:Min)
Recording Time (Day:Hour:Min)
Monitor Program
(continued)