CYALKIT-E02 Solar-Powered BLE Sensor Beacon Reference Design Kit Guide, Doc. No. 002-11317 Rev. *C
29
7. Push and release the RESET button (SW1) on the Debug Board. Note that when the Solar BLE Sensor is in this mode, it
stops transmitting BLE sensor data.
8. Confirm that the Solar BLE Sensor is in the command mode by observing that the
“Start…” message appears on Tera
Term. Your board is ready to receive commands.
9. For example, this step will set the Major
ID to “0x000a” (Hexadecimal) to receive another Solar BLE Sensor ID. On Tera
Term, type
major 000A
. The Solar BLE Sensor responds with a confirmation message as follows. Refer to section
for a list of all kit commands.
10. To confirm the operation of the changed parameter when using USB bus power, type
exit
. The board will acknowledge
the
command by responding with “exit.”
If you do not need to confirm the operation when using USB bus power, skip this step and the next one (step11).
SW1
Push
