PSoC® 4100S Pioneer Kit Guide, Doc. # 002-14067 Rev. *C
27
Kit Operation
3. Hold the kit as shown in
Figure 3-8
and pull the bottom side of the casing wall outwards. Hold the
USB connector and lift the board gently.
Figure 3-8. Pull the Main Board from the Case
Note that the main board needs to be removed slowly because it is connected to the Flex PCB. Flex
PCB is permanently attached to the top case. Do not attempt to separate the Flex PCB from the top
case. Instead, disconnect the Flex PCB from the main board by releasing the FPC connector, J10
(see
Figure 3-9
). The main board can be used for developing your own applications. Arduino shields
can be plugged into the main board using press-fit connectors provided with the kit.
3.1.2
Disconnecting Flex PCB from main board
The FPC connector, J10, is used to connect Flex PCB to the main board. To disconnect the Flex
PCB from the main board, flip up the latches of the FPC connector and pull out the Flex PCB.
Figure 3-9
shows the sequence of steps to be followed.
Figure 3-9. Disconnecting Flex PCB from Main Board
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
