PSoC® 4100S Pioneer Kit Guide, Doc. # 002-14067 Rev. *C
4
Safety Information
Regulatory Compliance
The CY8CKIT-041-41XX PSoC
®
4100S Pioneer Kit is intended for use as a development platform
for hardware or software in a laboratory environment. The board is an open-system design, which
does not include a shielded enclosure. This may cause interference to other electrical or electronic
devices in close proximity. In a domestic environment, this product may cause radio interference. In
such cases, you may be required to take adequate preventive measures. In addition, this board
should not be used near any medical equipment or RF devices.
Attaching additional wiring to this product or modifying the product operation from the factory default
may affect its performance and cause interference with other apparatus in the immediate vicinity. If
such interference is detected, suitable mitigating measures should be taken.
General Safety Instructions
ESD Protection
ESD can damage boards and associated components. Cypress recommends that you perform
procedures only at an ESD workstation. If an ESD workstation is not available, use appropriate ESD
protection by wearing an antistatic wrist strap attached to a grounded metal object.
Handling Boards
PSoC 4100S Pioneer Kit is sensitive to ESD. Hold the board only by its edges. After removing the
board from its box, place it on a grounded, static-free surface. Use a conductive foam pad if
available. Do not slide the board over any surface.
The PSoC 4100S Pioneer Kit, as shipped from the factory, has been verified to meet
with the requirements of CE as a Class A product.
The PSoC 4100S Pioneer Kit contains ESD-sensitive devices. Electrostatic charges
readily accumulate on the human body and any equipment, and can discharge without
detection. Permanent damage may occur on devices subjected to high-energy
discharges. Proper ESD precautions are recommended to avoid performance
degradation or loss of functionality. Store unused PSoC 4100S Pioneer Kits in the
protective shipping package.
End-of-Life/Product Recycling
The end-of life for this kit is five years from the date of manufacture mentioned as a bar
code on the back of the box. Contact your nearest recycler for discarding the kit.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
