PSoC® 4100S Pioneer Kit Guide, Doc. # 002-14067 Rev. *C
28
Kit Operation
3.1.3
Reassembling Kit Case
1. Connect the Flex PCB to the main board.
2. Flip the main board and gently push the Flex PCB under the main board.
3. Align the main board switches with respective slots on the top case.
4. Push the main board switches into the slots gently.
5. At the other end of the main board, gently press the board until you hear the click sound.
Note:
Make sure the onboard components or switch positions are not changed.
6. Hold the bottom case, align it to the potentiometer and Power Selection switch.
7. Press on all corners to close the bottom case.
3.1.4
Removing the Overlay
The kit case comes with an attached overlay that is imprinted with a
CIE 1931 color gamut
. This
overlay is intended to be used with the
CE214025 Trackpad With Color Gamut
code example, which is
pre-programmed into the PSoC 4100S Pioneer Kit. You can remove this if you intend to use the
trackpad without an overlay. Follow these steps to remove the overlay.
1. Hold the kit firmly and pull out the overlay from the corner, as shown in
Figure 3-10
. Use a sharp
edge object (e.g. a plectrum or a credit card) to pull the overlay from the corner.
Note:
Do not use your nails to remove the Overlay.
Figure 3-10. Removing the Overlay
2. Slowly lift the overlay off the case.
After removing the overlay, keep it in a dust-free place for longevity of the micro-suction tape.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
