CYP EL-8300VA, Operation Manual, Page: 20 / 98

14
unit automatically select an output resolution based on the detected
EDID of the connected display.
Note: Not active when HDMI bypass mode is enabled.
4) Aspect: Select the aspect ratio to use when outputting the source.
“Full” stretches the source to fill the output resolution, regardless
of the original aspect ratio, while “Best Fit” will always attempt to
retain the original source’s correct aspect ratio by adding black bars
if necessary. “Follow In” centers the source on the screen, without any
scaling (1:1 pixel reproduction).
Note: Not active when HDMI bypass mode is enabled.
5) No Signal Colour:
Select the colour to output when no input signal is
detected.
6) Blank:
Enable or disable blanking the video output.
Note: Not available when HDMI bypass mode is enabled.
7) Freeze: Enable or disable freezing the video output.
Note: Not available when HDMI bypass mode is enabled.
8) Auto Setting:
„
Auto Sync Off:
Sets the amount of time to continue outputting
sync with the free run colour if there is no live source and no
operations have been executed on the unit. Setting this to “OFF”
forces the unit to always output sync.
„
Auto Route: Enable or disable automatically switching to any
newly detected source.
9) HDCP Setting:
Selects the HDCP logic to use with the HDMI input.
Setting this to “Support Off” will completely disable HDCP support.
Note: The VGA input is not listed as it cannot support HDCP.