CYP EL-8300VA, Operation Manual, Page: 10 / 98

4
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Front Panel
USB-C DP HDMI 1 HDMI 2 HDMI 3 HDMI 4 HDMI 5 VGA
WUXGA
VIDEO IN HDMI OUT
BYPASS
POWER
MENU ENTER
1080P
- +
AMPLIFIER
LINE OUT
SELECT
VOLUME
MIC
SELECT
MIX
AUDIO OUT
EL-8300VA
1 2 3 4 5 6 7 8 9 10
1
POWER LED: This LED will illuminate to indicate the unit is on and
receiving power.
2
MENU Button: Press to enter the OSD menu, or to back out from
menu items.
3
MINUS (-) Button: Press to move down or adjust selections within
OSD menus.
4
PLUS (+) Button: Press to move up or adjust selections within OSD
menus.
Note: Pressing the “+” button when not in a menu will toggle the video
freeze feature.
5 ENTER Button:
Press to confirm a selection within the OSD or to go
deeper into a menu item.
Note: Pressing “ENTER” and “+” together will reset the output resolution to
WUXGA (1920×1200@60Hz). Pressing “ENTER” and “-” together will reset
the output resolution to 1080p@60Hz.
6 HDMI OUT BYPASS Button & LED:
Press this button to enable or
disable the HDMI video Bypass function. When bypass is enabled, the
LED will illuminate.
7
VIDEO IN Buttons & LEDs: Press any of these buttons to switch
immediately to the corresponding input. An LED will illuminate to
indicate which source is currently selected.
8 AUDIO OUT SELECT Button & LEDs: Press this button to select the
microphone mix mode of the unit. The LED will illuminate to indicate
the current mix mode. When both LEDs are off, the mixer is disabled.
Note: Activating Mixer On mode, or MIC Only mode will automatically
disable HDMI Out Bypass mode.
9
VOL. Button & LEDs: Press this button to select which audio output’s
volume is controlled by the volume knob. When both LEDs are off, the
knob controls the HDMI audio output (LPCM 2.0 only).