CYP EL-8300VA, Operation Manual, Page: 11 / 98

5
10 VOL. Rotary Knob & LEDs: Rotating the knob increases or decreases
the currently selected audio output’s volume level. The LED bar will
change according to the current level. Pressing in on the knob toggles
the audio mute function.
6.2 Rear Panel
1 2 3 4 5 6 IR IN IR OUT
L+
L+ L- R+ R-
L- G R+ R-
HDMI OUT CAT5e/6/7 OUT
SERVICE
LAN DC 24V
AUDIO OUT
RS-232
TX1
TX2
RX1
RX2
G
G
24V
24V OFF
48V
5V
TRIGGER IN
5V
G
1
5
2
6
4
8
3
7
RELAY
1 2
ANALOGUE AUDIO
DP HDMI 1 HDMI 2 HDMI 3 HDMI 4 HDMI 5
INPUT
USB-C
MIC IN
VGA
10 9 11 12 13 14 15 16 17
1 2 3 4 5 6 7 8
1
MIC IN Port & 48V/OFF/5V Switch: Connect to a standard
microphone using a 6.35mm plug. Set the switch based on the
phantom power requirements of the connected microphone.
Note: If no phantom power is required, this switch should remain in the
“Off” position to avoid potential damage to connected equipment.
2
ANALOGUE AUDIO INPUT 1~6 Ports: Connect to the analogue
stereo output of a device such as an audio player or PC.
Note: By default, Analogue Audio 1 is paired with the VGA input.
3 AUDIO OUT 5-pin Terminal Block:
Connect to powered speakers or
an amplifier for analog stereo audio output.
4 AUDIO OUT L/R 2-pin Terminal Blocks:
Connect to unpowered 4Ω
speakers for analogue stereo audio output. Up to 20W of power is
provided to each speaker.
5 TRIGGER IN 10-pin Terminal Block:
Connect to the Trigger Control
Keypad (Optional) or any device with trigger switch functionality
such as window security alarms, motion detectors, door switches, etc.
Each of the 8 triggers will activate an assigned unit function when
triggered.
Note: A minimum of 5V DC is required to activate a trigger.
6 RELAY 1~2 2-pin Terminal Blocks:
Connect to devices that can be
powered and controlled via a DC 0~24V/5A relay connection such as a
curtain, projection screen, or lights.
7 IR IN Port: Connect to an IR Extender to receive local IR control
signals and extend them to devices connected to the other end of
the HDBaseT connection. Ensure that the remote being used is within
direct line-of-sight of the IR Extender.