CynkoMet N-221/3-3, Instructions For Use And Operation, Page: 43 / 119

Cynko Met N-221/3-3
N-221/4-3
43
to third parties.
After completion of the machine coupling, check the security of
the hitch.
When connecting the braking system (two-wire pneumatic), the correct
sequence of connecting cables is important Be the first to connect the plug
marked yellow to a yellow socket in the tractor, and then the plug marked in
red to the red socket in the tractor. When you connect the second cable, the
brake release system will switch to the normal mode of operation
(disconnection or interruption of the air duct causes the trailer control valve
to automatically switches to the position of actuating the brakes of the
machine). The cables are marked with colored protective caps that identify
the correct cable installation
In order to disconnect the spreader from the tractor, perform the
following steps:

Use the hand brake in the tractor

After stopping the tractor, brake the trailer with a parking brake.

Use the parking brake in the tractor securing the possibility of the tractor
driving off.

Switch off the engine and remove the keys from the ignition.

If the spreader with the cargo is located on a steep slope or an elevation, it
should be protected additionally against rolling by planting chocks under rear
wheels.

Disconnect the hydraulic, electrical and brake system cables of the trailer
from the spreader.

When removing the pin, disconnect the drawbar from the transport hitch of
the tractor and drive the tractor away.

CAUTION!
CAUTION!
When disconnecting the spreader from the tractor, keep
particular caution.
Provide yourself a good visibility. Before disconnecting the hoses