CynkoMet N-221/3-3, Instructions For Use And Operation

Page: 40 / 119

Cynko Met N-221/3-3
N-221/4-3
40
4.3.2 Preparation for the spreader’s work.
In preparation for the spreader’s work, the following should be
checked:

the wear of the tires and driving wheels,

Air pressure in the tires,

tightening the nuts fixing the discs of the driving wheels to wheel hubs and the
condition of other screw connections.
In addition, after combining the machine with the tractor check:

the efficiency of the electrical system and lighting system and spreader signaling,

the effectiveness of the brake system,
4.3.3 Preparation for running, spreader as the transporter.
Preparation of the spreader to work as a transporter is started by
dismantling the rod ends of the swivels of the inner wall. After taking off the
ends of the wall swivels, secure the hydraulic cylinders against uncontrolled
sliding off and damage to both the coating and galvanizing of the spreader,
as well as damage to the face of the piston rod.
Then we dismount the inner wall by pushing it upwards until it is
outside the guides. You should pay particular attention to the fact that the
wall has not advanced rapidly and that there was no occurrence of loose
rotation of the wall on the sling. To take out the walls, use the front loader,
telescopic boom or other device with a lifting capacity of 100 kg.
After demounting the inner wall, proceed to the demounting of
the adapter with the guard. It is advisable to come from the back with a front
loader (telescopic system) with a capacity of at least 1000 kg and wear belts /
slings in handles located in the upper beam of the adapter (protection of the
adapter against uncontrolled fall). The adapter's drive chain, found on the
machine’s left side, is to be unlatched.
As soon as we have the adapter secured from falling and the drive
is disconnected proceed to unscrew the screws connecting the adapter
structures with walls and the frame of the spreader. After removing the