Cynko
Met
N-200
Page 32
done manually due to the mini-spreader’s low maximum load capacity.
Loading is to be performed in such a way that the material loaded
onto the cargo bed is evenly distributed. The goal of the uniform
loading is to optimize the dispersion of the material during operation
of the spreader and its stability.
NOTE!
NOTE!
It is absolutely required from the user to verify whether the
material loaded on the spreaders are not solids such as stones,
pieces of wood, metal parts, wires, etc., and if so, to remove
them immediately. Failure to do so may result in permanent
damage to the structure of the machine and void the warranty,
and what is worse impact of such elements on bystanders or
animals.
NOTE!
NOTE!
Loading of the spreader with aggregated material should be
done gradually depending on the material being spread and the
substrate over which the spreader will be moving.
4.3.4 Coupling and decoupling with the drawing machine.
The spreader can be coupled to a drawing vehicle that has a ball hitch
adapter for hitching with a BC-1200 hitching head.
Coupling and decoupling should always be done manually, while drives
are disengaged (angled lever position).
NOTE!
NOTE!
Coupling of the spreader using a hitch other than the ball hitch is
prohibited, as it poses a safety hazard to the operator and to
