Cynko
Met
N-200
Page 28
Make sure that the hitch on the drawbar of the mini-spreader is adapted to
the ball hitch of the drawing vehicle.
Check whether all guards are in place and their condition does not raise
doubts.
Trial drive / start
If all the above steps have been performed and the technical condition of
the spreader does not raise any objections, connect the machine to the
drawing vehicle in compliance with the following sequence:
Switch off the machine to which the mini-spreader is to be coupled
(remove the key from the ignition switch).
Couple the spreader to the ball hitch by pulling it manually to the
drawing vehicle, and make sure that the drive control level is in the
angled position (drives disengaged).
Couple the spreader, making sure that the coupling is working correctly
(secure the coupling).
Raise the adjustable support and set the wheel of the support facing up
(so that during driving it does not catch on the ground).
Remove the rear adapter guard and fasten it on the brackets on the
front wall of the spreader, and secure it with safety pins.
Raise the interior wall to the inclined position, the wall should be found
within the channel bars of the fastening.
Engage the drives of the adapter and chain conveyor with the mini-
spreader's driving wheels by setting the lever from angled position (1)
to vertical position (2), as shown in (figure 9).
