Cynko
Met
N-200
Page 12
3.2
Attaching and detaching the machine to the tractor
Before attaching the mini-spreader, make sure that the driving vehicle and
spreader are technically efficient.
When coupling the spreader, use only a ball hitch. After completion of the
machine coupling, check the security of the hitch. Be very careful when you
connect the machine.
During coupling of the mini-spreader, the driving machine and engine must
be switched off, and the key should be removed from the ignition switch.
Next, the mini-spreader (without cargo) should be pulled to the driving
vehicle manually and coupled to the ball hitch. The coupling should be
checked thoroughly.
After coupling the mini-spreader, raise the adjustable support to its maximum
height, so that it does not come into contact with the floor during driving,
and lock it into place. If the support comes into contact with the floor during
driving, it may be damaged, and in extreme cases, even damage the mini-
spreader.
3.3
Tires on driving wheels
When working with tires, secure the spreader so that it cannot move.
Tire change should be performed on a stable base in which the wheel cannot
become embedded. After every tire change, tighten the nuts after the first 10
work-hours, and then check their tightness every 50 work-hours.
The air pressure is to be checked regularly. Use the recommended pressure
350 bar.
Dismantling the wheels can be carried out only in the case when the spreader
is not loaded.
Avoid quick and variable maneuvers and high speed during turns.
Tire valves are to be protected with caps to prevent penetration of impurities.
3.4
Adapter drive system
During maintenance of the adapter's drive, first make sure that the mini-
spreader is secured against uncontrolled movement:
