Cumberland Expert-32P, User Manual

Page: 15 / 76

15 Expert-32P rev.11
Expert-32P
key once again to adjust the number of clock outputs used.
19. Number of Inlet Outputs / Tunnel
Ventilation: Press the Edit key to adjust
the number of inlets used. Press the Edit
key once again to enable or disable tun-
nel ventilation. Note that the inlet is not
available if the control uses a static pres-
sure sensor to operate vent doors.
21. Tunnel Control
Press the Edit key and select whether the
tunnel curtain is controlled by the static
pressure level or if its moving time is
based on the activation of ventilation
stages.
22. Vent Doors : Press the Edit key to
enable or disable vent doors. Note that
the vent doors can only be activated if
the static pressure sensor is enabled.
23. LED Display Mode : Press the Edit
key to change the display mode on the
LED display on the top right of the con-
trol panel. You can choose between the
temperature (T), the static pressure (SP)
or an alternating display of both the tem-
perature and the static pressure (T/SP).
24. Brooding / Grow Out Setup : Press
the Edit key to enable or disable a brood-
ing /grow out setup.
25. Day/Night Set Points : Press the
Edit key to enable or disable separate
day and night set points.
Use vent door?
NO
Display:
T only
Use Brooding/
Grow out? NO
#Inlets 0
Use tunnel? NO
Tunnel control:
Static Pres.
Use Night
Settings? NO