CU-ERT Operator’s Manual_ver 1.10
46
8.3 DATA TRANSFER TO PERSONAL COMPUTER
The data from the previous rescue operation stored in the internal flash memory or the SmartMedia
card is overwritten every time the Paramedic CU-ERT is used in a rescue operation.
To keep data permanently, it must be transferred to a computer that is running the CU Expert ECG
Data Management Software. The CU Expert is an optional data management software available from
CU Medical Systems, Inc.
Data transfer can be done through the IrDA port or the UART port of the Paramedic CU-ERT.
8.3.1 IrDA
Connect the IrDA transceiver to the COM1 or COM2 serial port of the PC hosting the CU Expert ECG
Data Management Software.
Align the IrDA transceiver with the IrDA port of the Paramedic CU-ERT. Insert the SmartMedia Card if
the data to be transferred is in the SmartMedia Card. See the illustrations on the CU Expert User’s
Manual
The Paramedic CU-ERT must be set to communicate through its IrDA port by setting the COM PORT to
IrDA as outlined in the GENERAL DEVICE SETUP of the section on MENU OPERATION.
Transmit the data from the Paramedic CU-ERT through the following steps:
a.
Open the CU Expert ECG Data Management Software.
b.
Turn the Paramedic CU-ERT ON. Do not connect any cable connector to the ECG-DEFIB port (AED
pads assembly or ECG Monitoring Cable Connector assembly.)
c.
Go to the CU Expert and begin data reception by executing the instructions spelled out in its
User’s Manual.
d.
Go back to the Paramedic CU-ERT. Activate the MENU by pressing the MENU button. Go to
COMMUNICATION-DATA TRANSMISSION. The following screen should be displayed.
L
#
©
'
COMMUNICATION
`
RETURN
'
DATA RECEPTION
DATA TRANSMISSION
