32
2.5.12 VLAN command
1. Create a 802.1q VLAN and management VLAN rule.
VLAN dot1q command
Parameter Description
Switch(config)# vlan dot1q-vlan
Globally enable 802.1q VLAN.
Switch(config)# vlan dot1q-vlan
[1-4094]
[1-4094]
Enter a VID number to create a 802.1q VLAN.
Switch(config)# vlan dot1q-vlan
isolation
Enable VLAN isolation mode. When “Isolation”
mode is enabled, the device will be forced to
follow the port-based VLAN rule shown below.
Port 1
2
3
4
5
6
1
V
V
2
V
V
3
V
V
4
V
V
5
V
V
6
V
V
V
V
V
V
Switch(config)# vlan
management-vlan [1-4094]
management-port [port_list]
[1-4094]
Enter the management VLAN ID.
[port_list]
Specify the management port number.
VLAN & Interface command
Switch(config)# interface
[port_list]
[port_list]
Enter several discontinuous port numbers
separating by a comma or a range of ports with
a hyphen. For example:1,3 or 2-4
Switch(config-if)# vlan dot1q-
vlan access-vlan [1-4094]
[1-4094]
Set up the selected ports‟ PVID.
Switch(config-if)# vlan dot1q-
vlan trunk-vlan [1-4094]
[1-4094]
Assign the selected ports to a specified VLAN.
Switch(config-if)# vlan dot1q-
vlan mode access
Set the selected ports to
access mode (untagged).
See the table
below for
ingress/egress
port behavior
for each
mode.
Switch(config-if)# vlan dot1q-
vlan mode trunk
Set the selected ports to trunk
mode (tagged).
Switch(config-if)# vlan dot1q-
vlan mode trunk native
Set the selected ports to trunk
native moe.
Switch(config-if)# vlan dot1q-
vlan mode dot1q-tunnel
Set the selected ports to dot1q
tunnel mode.
Switch(config-if)# vlan port-
based [name]
[name]
The names
can be
entered are:
port1vlan
,
port2vlan
,
port3vlan
,
Set the selected ports to a specified port-based
VLAN. By default, every port is a member port
in each port-based VLAN.
Summary of Contents for HET-2106 SERIES
Page 79: ...79 Restart DHCP service...
