CTS HET-2106 SERIES, User Manual

Page: 23 / 82

23
3. Set up QoS queuing mode.
Queuing-mode command Parameter Description
Switch(config)# qos queuing-
mode [weight] [weight] By default, “weight” queuing mode is used.
If you want to use “strict” queuing mode,
you need to disable “weight” queuing
mode.
Strict mode: This indicates that services
to each egress queues are offered based
on rates specified. Use
“ qos rate-limit
egress [0-7] [rate] ” to specify egress rate
in Strict mode.
Weight mode : This mode enables users
to assign different weights to 4 queues.
Use
“ qos queue-weighted [0-4] ” to specify
egress rate in Weight mode.
No command
Switch(config)# no qos queuing-mode Set the queuing mode to Strict mode.
Show command
Switch(config)# show qos Show or verify QoS configurations.
Queuing-mode example
Switch(config)# qos queuing-mode weight Change the queuing mode from strict to
weight.
4.
Assign a tag priority to the specific queue.
802.1p-map
command
Parameter Description
Switch(config)#
qos 802.1p-
map [0-7]
802.1p_list [0-
3] [0-7]
802.1p_list Assign a 802.1p priority bit or several 802.1p priority bits for
mapping.
Set up the corresponding priority value
Priority
Level
Low Low Low Normal Medium Medium High High
802.1p
Value
0 1 2 3 4 5 6 7
[0-3] Assign a queue value for mapping.
No command
Switch(config)#
no qos 802.1p-
map [0-7]
802.1p_list [0-7]
802.1p_list Assign a 802.1p priority bit or several 802.1p priority bits that
you want to delete or remove.
Show command