CTP Systems CTPhone 1900, Applications Manual

Page: 51 / 132

DOC00101-01 3-3
CTPhone 1900 System Hardware & Software Installation
Recommended Installation Order
Following is the recommended order for installing your CTPhone 1900
system.
Table 3-A. Installation Order
Task Instructions
1 Install system cabling. page 3-4
2 Complete base station installation. page 3-8
3 Complete physical installation and grounding of the
CTPhone Controller. Do not connect the CTPhone
Controller to power at this point. page 3-13
4 Connect a personal computer to the CTPhone Con-
troller. page 3-17
5 Install CTPhone Manager software on the personal
computer. page 3-21
6 Copy CTPhone software onto the personal com-
puter. You must copy the software to the SOFT-
WARE subdirectory underneath the CTPhone
Manager directory. page 3-22
7 Start the CTPhone Manager and open the Status
Window. page 3-22
8 Connect the power cable to the CTPhone Controller.
Then connect the cable to power. (You’ll see warning
messages in the status window; this is normal.) page 3-13
9 Using the CTPhone Manager, perform a software
upgrade to upload the CTPhone software from the
personal computer to CTPhone Controller. page 3-23
10 Perform UTAM activation (if required). page 3-24
11 Configure System Settings. page 3-24
12 Repeat the software upgrade process to complete
loading software from the personal computer to the
base stations.
page 3-25
13 Check CTPhone Controller LEDs to make sure they
do not indicate any failures. Note that dim or flashing
LEDs may indicate a problem.
If LED S2 on the CTPhone Controller remains lit after
powering the CTPhone Controller trying reloading
software using the instructions on page 3-25.
page 5-9
14 Check base station LEDs to make sure they do not
indicate a failure. Note that dim or flashing LEDs may
indicate a problem.
page 5-11
15 If the LEDs indicate a problem, use troubleshooting
procedures to determine the problem.
page 5-2