DOC00101-01
3-25
CTPhone 1900 System Hardware & Software Installation
4
Click on
to send the system settings to the base stations.
Repeating the Software Upgrade
To complete uploading software to the base stations, repeat the steps
listed in Performing a Software Upgrade (First-Time) on page 3-23.
Following is an example of the status messages that appear when the
upgrade is successful and call processing software is running on the
CTPhone Controller.
The status window may also report alarms; if you have a question about
an alarm, check the CTPhone Manager on-line help for information on sys-
tem alarms.
Note If the software upgrade does not complete successfully, repeat the
upgrade procedure. The message Waiting for Wireless Manager must
appear in the Status window before the first Rebooting Wireless Controller
progress bar times out.
Software Reloading
If LED S2 on the CTPhone Controller remains lit after powering the
CTPhone Controller, you should try reloading software. (See CTPhone
Controller LEDs on page 5-9 if you need more information.)
To reload software, follow instructions in Performing a Software Upgrade
(First-Time) on page 3-23.
- WF Controller Boot SW Version B19.00 -
SRAM Test Passed
Boot Flash Cksm Passed
CP Flash Cksm Passed
CMOS Battery Passed
Real Time Clock Passed
Clock Interrupt Passed
SCT #1 Passed
SCT #1 LLB Passed
SCT #1 Interrupt Passed
SCT #2 Passed
SCT #2 LLB Passed
SCT #2 Interrupt Passed
-Call Processing Software Version xx.xx -
Waiting for Wireless Manager
- WF Controller CP SW Started -
12:10:09 06/13/96
Summary of Contents for CTPhone 1900
