CTC Union GSi 16, Installation And Maintenance Manual

Page: 79 / 120

79
CTC GSi 16
Dag 1 2 3 4 5 6 7 8 9 osv
ºC
#1.
#2.
#1. #3. #2. 10 dagar
58 ºC -5 ºC
Room temp. DHW Operation
Drying period active 1 / 12 (25)
CTC GSi 12 Monday 09:35
CTC GSi 16
Drying period mode
Off(Off/1/2/3)
Floor drying function for newly-built properties.
The function limits the calculation of primary flow
temperature (setpoint) for “Your home’s heating
settings” to the schedule below.
Mode 1
Floor drying function for 8 days.
#1. Heating circuit setpoint is set at 25 °C for 4 days.
#2. Days 5-8 use preset value Drying period temp °C.
From Day 9 onwards the value is calculated
automatically according to “Your home’s heating
settings”.
Mode 2
Drying period for 10 days + stepped increase and
decrease.
#1. Stepped increase start. The setpoint for the
heating circuit is set to 25 °C. The setpoint is then
raised by 5 °C each day until it is equal to the Drying
period temp °C.
The final step may be less than 5 °C.
#3. Stepped decrease. After the stepped increase
and 10 days at an even temperature, the temperature
setpoint is reduced to 25 °C in daily 5 °C stages.
The final step may be less than 5 °C.
Following the stepped decrease and one day at the
setpoint of 25 °C, the value is calculated automatically
according to “Your home’s heating settings”.
Mode 3
This mode starts with Mode 1, followed by Mode 2
and finally by “Your home’s heating settings”.
Drying period temp °C
25 (25—55)
Here you set the temperature for #2 as shown above.
Example for Mode 1 with Drying period temp °C: 38 °C.
“Your home’s heating settings”
“Your home’s heating settings”
Example for Mode 2 with Drying period temp °C: 37 °C.
Example of operation data for Mode 2, Day 1 of 12
with current setpoint (25) °C.
30
20
Day
1 2 3 4 5 6 7 8 9 10 11 12 13 and so on
30
20
°C
40
40