Page | 38
average heart rate will reduce further and further. Therefore, after training, stop the
timer (stopwatch) in order to obtain a meaningful heart rate.
Why are the times specified within, above and below the training zone not correct?
This is probably because you did not stop the timer (stopwatch) in heart rate mode
after training. This is why the time for these values continues to run. Please stop the
timer (stopwatch) in heart rate mode after training.
Why does the LED indicator / training zone alarm stop, although the heart rate
frequency is displayed?
This can happen for the following reasons:
-
A disruptive signal from the near vicinity is falsifying the measurement values
-
A very irregular heart frequency is measured. Under certain circumstances,
this can occur at the start of training and in a condition of exhaustion and will
depend on the individual’s physical status.
In order to avoid incorrect information from the LED indicator / training zone alarm,
these warning signals are stopped in such cases.
Please also note that the intervals for the training zone alarm and the LED indicator
are different depending on the training zone selected.